Honda GL1800 2020, Owner'S Manual

Page: 180 / 266

176
Ma
in
te
na
nce
Final Drive Oil
Checking the Final Drive Oil
1. Hold the vehicle upright on firm level
ground.
2. Remove the oil fill hole cap and O-ring.
3. Check the oil level. It should be flush
with the lower edge of the oil fill hole.
Adding Final Drive Oil
If the final drive oil level is low, check for oil
leaks. Add the recommended final drive oil
(
2
P. 160) until it reaches the lower edge of
the opening.
1. Pour the final drive oil into the oil fill
hole until it reaches the lower edge of
the opening.
u
Do not over fill above the lower edge
of oil fill hole.
u
Make sure no foreign objects enter
the oil fill hole.
u
Wipe up any spills immediately.
2. Install a new O-ring onto the oil fill hole
cap. Tighten the oil fill hole cap.
Changing Final Drive Oil
1. Hold the vehicle upright on firm level
ground.
2. Place a drain pan under the drain bolt.
3. Remove the oil fill hole cap, O-ring,
drain bolt, and sealing washer to drain
the oil.
4. Install a new sealing washer onto the
drain bolt. Tighten the drain bolt.
5. Fill the final gear with the recommended
oil.
2
P. 160
6. Check the oil level. It should be flush
with the lower edge of the oil fill hole.
7. Install a new O-ring onto the oil fill hole
cap. Tighten the oil fill hole cap.
8. Check that there are no oil leaks.
Lower edge
Oil fill hole cap
O-ring
Torque: 8 N·m (0.8 kgf·m, 5.9 lbf·ft)
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Required oil: 140 cm 3 (4.7 US oz,
4.9 Imp oz)
Torque: 8 N·m (0.8 kgf·m, 5.9 lbf·ft)
Oil fill hole cap
O-ring
Sealing washer Drain bolt
Lower edge
20 GL1800 32MKC820.book 176 ページ ２０１９年９月２０日 金曜日 午後３時９分