Honda GL1800 2020, Owner'S Manual

Page: 177 / 266

Engine Oil u Changing Engine Oil & Filter
173
Ma
in
te
na
nce
6. Remove the oil filter with a filter
wrench and let the remaining oil drain
out. Make sure the prior seal is not
stuck to the engine.
u
Discard the oil and oil filter at an
approved recycling centre.
7. Apply a thin coat of engine oil to the
rubber seal of a new oil filter.
8. Install the new oil filter and tighten.
9. Install new sealing
washers onto the drain bolt A, drain
bolt B and drain bolt C. Tighten the
drain bolts to the specified torque.
Install new sealing washer
onto the drain bolt. Tighten the drain
bolt to the specified torque.
10. Fill the crankcase with the
recommended oil (
2
P. 159, 253, 255)
and install the oil fill cap.
11. Check the oil level.
2
P. 171
12. Check that there are no oil leaks.
Torque: 26 N·m (2.7 kgf·m, 19 lbf·ft)
Seal
rubber
Oil filter
Torque:
Drain bolt A:
30 N·m (3.1 kgf·m, 22 lbf·ft)
Drain bolt B:
30 N·m (3.1 kgf·m, 22 lbf·ft)
Drain bolt C:
30 N·m (3.1 kgf·m, 22 lbf·ft)
Drain bolt:
30 N·m (3.1 kgf·m, 22 lbf·ft)
GL1800BD/DA
GL1800/B
GL1800BD/DA:
GL1800/B:
Required oil:
When changing oil & engine oil
filter:
4.6 litres (4.9 US qt, 4.0 Imp qt)
When changing oil only:
4.4 litres (4.6 US qt, 3.9 Imp qt)
When changing oil & engine oil
filter:
3.7 litres (3.9 US qt, 3.3 Imp qt)
When changing oil only:
3.5 litres (3.7 US qt, 3.1 Imp qt)
GL1800BD/DA:
GL1800/B:
20 GL1800 32MKC820.book 173 ページ ２０１９年９月２０日 金曜日 午後３時９分