160
Adjustments for Competition
Personal Fit Adjustments
Refer to an official Honda Service Manual for installation instructions. Be sure to check control cable and
wiring harness routing after the adjustment.
Position chart
Handlebar position
Handlebar lower holders position
Handlebar lower holders
Forward 1 in (26 mm)
Front holes of fork bridge
No change
Forward 0.6 in (16 mm)
Front holes of fork bridge
Rotating 180 degrees
Standard
Rear holes of fork bridge
No change
Backward 0.4 in (10 mm)
Rear holes of fork bridge
Rotating 180 degrees
• Handlebar width can be trimmed with a
hacksaw to better suit your particular shoulder
width and riding preference. Think this
through carefully and cut off just a small
amount at a time from both sides equally. It is
obviously much easier to make the handlebar
narrower than it is to add material.
• Chamfer the edges to remove burrs and other
irregularities or roughness after sawing the
handlebar.
• An alternate handlebar shape, through varying
rise or rearward sweep dimensions, will
provide further adjustment to riding position
and may better suit your particular body size or
riding style. Each of the ergonomic dimensions
of the machine was determined to suit the
greatest possible number of riders based on an
average size rider.
Summary of Contents for CRF450R 2020
