Honda CR-V Hybrid 2020, Owner'S Manual

Page: 197 / 687

195
uu Operating the Switches Around the Steering Wheel u Wipers and Washers
Continued
Co
ntrols
Wipers and Washers
The windshield wipers and washers can be
used when the power mode is in ON.
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT *1 , AUTO *2 , LO,
HI)
Move the lever up or down to change the
wiper settings.
■
Adjusting wiper operation *
Turn the adjustment ring to adjust the wiper
operation.
■
Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
then stop.
*1: Models with manual intermittent operation
*2: Models with automatic intermittent operation
■
Windshield Wiper/Washer
1 Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
NOTICE
In cold weather, the blades may freeze to the
windshield.
Operating the wipers in this condition may damage
the wipers. Use the defogger to warm the
windshield, then turn the wipers on.
NOTICE
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation’s
shortest delay setting (
) and the LO setting become
the same.
If the wipers stop operating due to an obstacle such
as the build-up of snow, park the vehicle in a safe
place. Rotate the wiper switch to
OFF , and set the
power mode to ACCESSORY or VEHICLE OFF, then
remove the obstacle.
Models with intermittent time adjustment ring
Intermittent Time
Adjustment Ring
*
MIST
INT *1 / AUTO *2
OFF
LO : Low speed wipe
Pull to
use
washer.
HI : High speed wipe
Lower speed, fewer sweeps
Higher speed, more sweeps
* Not available on all models
20 CR-V HYBRID HMIN-31TPG6000.book 195 ページ ２０１９年１１月２８日 木曜日 午後１時５０分