Honda CBF190WH 2016, Shop Manual

Page: 27 / 130

FUEL & ENGINE
2-2
FUEL & ENGINE
FUEL LINE
• This vehicle uses resin for the part of materials in the fuel
feed hose. Do not bend or twist the fuel feed hose.
• Fuel tank center cover  3-7
• Fuel pump 5P connector
• Let the engine idle until it stops.
• Battery negative (–) cable  4-28
• Do not use tools in removal. If the connector does not
move, alternately pull and push the connector until it
comes off easily.
• Check the fuel quick connect fitting for dirt, and clean if
necessary.
• Place a shop towel over the quick connect fitting.
•
Push the retainer tab forward.
• Press down the retainer and disconnect the connector
from the fuel pump joint/injector joint.
• Check the retainer condition and replace the fuel hose if
necessary.
• To prevent damage and keep foreign matter out, cover the
disconnected connector and pipe end with the plastic
bags.
• Press the connector onto the fuel joint until the retainer
locks with a “CLICK”. If it is hard to connect, put a small
amount of engine oil on the pipe end.
• Make sure the connection is secure; check visually and by
pulling the connector.
• After installing the removed parts, turn the ignition switch
ON. (Do not start the engine.)
The fuel pump will run for about 2 seconds, and fuel
pressure will rise. Repeat 2 or 3 times, and check that
there is no leakage in the fuel supply system.