To erase the codes stored in all three
buttons, press and hold the two
outside buttons until the red light
begins to flash, then release the
buttons.
You should erase all three codes
before selling the vehicle.
If you have problems with training
the HomeLink Wireless Control
System, or would like information on
home products that can be operated
by HomeLink, call (800) 355-3515.
On the Internet, go to www.
homelink.com.
HomeLink is a registered
trademark of Johnson Controls, Inc.
As required by the FCC:
This device complies with Part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications not expressly
approved by the party responsible for
compliance could void the user’s
authority to operate the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must
accept any interference that may cause
undesired operation of the device.
Erasing Codes
Retraining a Button
Customer Assistance
HomeLink Universal Transceiver
158
０４／０５／２７ １８：０８：３９ ３１ＳＤＡ６２０ ０１６１
If you want to retrain a
programmed
button for a ne
w device, you do
not have to eras
e all button memory.
You can
replace the existing memory
code
for that button using this
procedure:
If a rolling code transmitter
was previously programmed,
the indicator will flash rapidly
for 2 seconds, then stay on
for about 23 seconds.
If a standard transmitter was
previously programmed, the
indicator will stay on for about
25 seconds.
begins to flash slowly, continue
to hold the HomeLink button,
and follow steps 3 thru 6 under
‘‘Training HomeLink’’ (see
page
155
).
2. Once the HomeLink indicator
button to be trained until the
HomeLink indicator begins to
flash slowly.
1. Press and hold the HomeLink
Main Menu
Table of Contents
▲
▼
