2001 American Honda Motor Co., Inc. -- All Rights Reserved
12 of 16
AII 22912 (0109)
15. Install the receiver line, the discharge hose, and the condenser line.
RECEIVER LINE
(Receiver-dryer fitting)
Apply a few drops of
refrigerant oil to the fitting,
then connect the
condenser line to the
receiver-dryer with a
6 x 25 mm flange bolt
(95701-06025-08). Torque
the bolt to 10 N
.
m (7 lb-ft).
Apply a few drops
of refrigerant oil
to the fitting,
then connect the
receiver line to the
receiver-dryer with a
6 x 25 mm flange bolt
(95701-06025-08).
Torque the bolt to
10 N
.
m (7 lb-ft).
Tilt the radiator and condenser back
into place, and install the condenser line.
Apply a few drops of refrigerant oil to the fitting,
then connect the condenser line to the condenser
with a 6 x 25 mm flange bolt (95701-06025-08).
Torque the bolt to 10 N
.
m (7 lb-ft).
Slide the receiver-dryer fitting on the receiver
line through the cutout in the bulkhead.
BULKHEAD
CUTOUT
Release this wire
harness clip.
Torque the fitting to 13 N
.
m (9 lb-ft).
Make sure you use a second
wrench to hold the other fitting.
Apply a few drops of refrigerant oil to
this fitting, then connect the receiver
line to the evaporator by moving the
vehicle harness aside. Loosely install
the fitting; do not tighten at this time.
Snap the receiver
line into the clamp.
Install the
receiver line clamp
(80381-SV7-A01).
Install the receiver
line clamp
(80381-SV7-A01)
to the suction
hose bracket
(80363-S84-A00).
Snap the receiver line
into the clamp.
Secure the suction hose
bracket using the 6 mm bolt
removed from the battery
cable holder.
Tilt the radiator and condenser toward the engine,
and install the discharge hose. Apply a few drops of
refrigerant oil to the fitting, then connect the discharge
hose to the condenser with a 6 x 25 mm flange bolt
(95701-06025-08). Torque the bolt to 10 N
.
m (7 lb-ft).
