EN 51
TROUBLESHOOTING
PROBLEM
LIKELYCAUSE
SOLUTION
7.
Engine stops when
blades are engaged
8.
The battery warning
light does not turn off
after a few minutes’
work
9.
The oil warning light
comes on while work-
ing
(
HF2220)
10.
The engine stops
and an audible signal
is heard
11.
The engine stops
with no audible warn-
ing
12.
The blades warn-
ing light stays lit when
the blades are disen-
gaged
(
models with
lever operated
engagement)
13.
The blades do not
engage
(
models with
lever operated
engagement)
➤
➤
➤
– you are not ready to engage the blades
(
☛
5.2)
– recharging of the battery insufficient
– problems in lubricating the engine
The protection of the electronic card has
cut in due to:
– earthed micro-switch
– battery contains electrolyte but is not
charged
– overvoltage caused by the charge reg-
ulator
– badly connected battery (poor contact)
– engine badly earthed
– battery disconnected
– no earth contact on engine
– problems in the engine
– the lever does not return to the disen-
gaged position due to accumulated
grass cuttings at the end of its stroke
– cable lengthened or belt loosened
– sit firmly on the seat (if problem contin-
ues, check micro-switch)
– check that the grass-catcher or stone-
guard are correctly in position (if prob-
lem continues, check micro-switch)
– check connections
Turn the key immediately to «STOP»:
– top up the oil level (
☛
5.3.3)
– replace the filter (if the problem contin-
ues, contact your Dealer
Turn the key to «STOP» and look for the
cause of the problem:
– check connections
– recharge battery (
☛
6.2.5)
– contact your Dealer
– check connections i (
☛
3.4)
– check engine earth connection
– check connections (
☛
3.4)
– check the earth connection on the
engine
– contact your Dealer
– free the joint of all the grass (accessed
from the inspection hatch)
– turn the adjusting nut (
☛
6.3.3)
