7
Priming
Spraying
This is only a quick reference. Read the entire instruction manual prior to using the product.
Submerge suction tube in paint. Turn Power Switch ON, and trigger gun into
waste pail. When paint comes out of return tube, turn Prime/Spray valve to
SPRAY. When paint comes out of gun, release trigger. Pump will build up
pressure and motor will stop.
Put trigger safety lever in locked
position.
NOTE: Always lock the trigger
when not in use, while performing
maintenance or during set-up and
cleaning.
1
PRI M
E
S
P
R
AY
2
Install tip and guard on gun and hand
tighten. If tip clogs, reverse spray tip
to quickly clear obstructions without
dissasembly. (Refer to Page 8 for
assembly instructions)
Correct solid spray pattern
Incorrect spray pattern with “tails”
4
FAST START QUICK REFERENCE GUIDE
Transfer Return Tube to paint pail.
3
Setup
Remove spray tip and guard from gun.
During first use of Spray Gun, Spray Tip
and Guard will be off of the Spray Gun.
1
Connect hose to gun and sprayer.
2
Turn Power Switch OFF. Plug sprayer
into grounded outlet.
3
bar/MPa/psi
Turn pressure control knob
clockwise to increase pressure
and counter-clockwise to decrease
pressure at the gun.
bar/MPa/psi
3
bar/MPa/psi
Unlock trigger safety lever. Point gun
12" from surface and begin moving
gun before triggering. If tails persist at
highest pressure, switch to smaller tip
or thin material.
Flushing
Turn pressure control knob counter-
clockwise to minimum pressure.
Turn Spray/Prime valve to PRIME.
bar/MPa/psi
1
Place Return Tube into waste pail.
Submerge suction tube in water
(water-based materials) or thinner/
cleaner solution (oil-based materials.)
2
4
Turn Power Switch ON. Turn Pressure
Control Knob clockwise until pump
starts.
3
bar/MPa/psi
Allow fluid to flow out of prime tube
into waste pail for 30-60 seconds.
Turn power switch OFF.
P
R
IM
E SP
R
A
Y
1
2
Spray
Clean
BULLETIN
If sprayer will not prime, remove
suction tube from unit and insert
a screwdriver to release the inlet
valve. Refer to D in the “Sprayer
starts, but does not draw in paint ...”
section in Troubleshooting.
