ZTH100 Operating Instructions
060902
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
20
Alternatively, if the group is named, the name will be displayed:
The text is displayed for a few seconds or until transmission is complete depending on which of these actions occurs
last.
If no group of the selected number is defined, the following message will be shown for a few seconds:
If for some reason the transmission fails, the following message will be shown until the user presses a key:
5.2.1.2 HOLDING A SPEED BUTTON DOWN.
Once a group is created on a speed button, it will start dimming when the speed button is held down.
The remote will listen for node information frames while the button is held down. If it detects a node-information frame
from a valid (reset/valid ID) node, it will add this node to the group being dimmed.
This figure illustrates the display during dimming:
Note that once a module is at maximum or minimum dim level the dimming will stop. The button must be released
and held down again in order to change dim direction. If a node information frame is detected during dimming, the
