ZTH100 Operating Instructions
060902
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
19
5. OPERATION MODE
5.1 OPERATION DISPLAY
When the clock is displayed the remote control is in operation mode. It is from this mode the known units can be
controlled through either groups or scenes.
5.1.1 SLAVE REMOTE INDICATION
When an underscore is shown in the left bottom corner the remote transmitteris a secondary remote with the limitations
mentioned in these instructions.
5.1.2 SCENE INDICATION.
From the operation mode press the scene prefix button “S”. The display will change to:
This indicates that the next key press will be used to control a scene (if any available).
5.1.3 LOW BATTERY INDICATION.
This message indicates that it is time to replace the batteries. It will go away when the batteries have been replaced.
5.2 USING OPERATION MODE
Operation mode is the mode where the following display is indicated:
This mode is also the idle mode to which the remote returns after performing operations.
In this chapter the functions available in operation mode will be described.
5.2.1 CONTROLLING GROUPS USING SPEED BUTTONS.
Groups are controlled by either using the keys 1 through 6 or by using the navigation keys (‘<‘ or ‘>’) to select the group
that is to be controlled. Note that dimming a group never displays any failures that might have happened during
transmission as does an ON/OFF command.
5.2.1.1 PRESSING A SPEED BUTTON BRIEFLY.
The buttons marked 1 through 6 are used for speed access to the first 6 groups or scenes. Pressing the number button
briefly will toggle the selected group on or off. Even if the remote is powered down (display is off) a key press on a speed
button will toggle the group. The display will show the following message: