HomeMatic HmIP-WRCC2, Mounting Instruction And Operating Manual

Page: 39 / 50

39
Start-up
with the back side to the wall at the position
where it should subsequently be attached
(see
figure 7) .
5.2.2 Screw mounting
When selecting the installation location, check
for electrical wires and power supply cables.
To install the device using screws, proceed as follows:
• Choose a site for installation.
• Position the wall mounting bracket
(E) on the
desired mounting position. Make sure that the
arrows of the mounting plate point upwards
(see
figure 8) .
• Use a pen to mark the positions of the two bore
holes (G) according to the mounting plate with a
distance of 67 mm on the wall (see figure 8) .
• Drill the marked holes (see fig. 9) .
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs
supplied. If you are working with a wooden wall,
you can pre-drill 1.5 mm holes to make screws
easier to insert.
• Use the supplied screws and plugs to fasten the
mounting plate to the wall (see figure 10) .
• Insert of the push-button unit (A) into the wall