37
Start-up
Make sure that no electricity or similar lines run in
the wall at this location!
• Position the mounting plate
(D)
on the desired
site on the wall. Make sure that the arrow on the
mounting plate is pointing upwards.
• Use a pen to mark the positions of bore holes
(H)
(diagonally opposite) in the mounting plate on
the wall
(see figure 5)
.
• Now drill the bore holes.
If you are working with a stone wall, drill the
marked two 5 mm holes and insert the plugs sup-
plied. If you are working with a wooden wall, you
can pre-drill 1.5 mm holes to make screws easier
to insert.
• Use the supplied screws and plugs
(I)
to fasten
the mounting plate to the wall
(see figure 6)
.
• Attach the clip-on frame
(A)
to the mounting plate.
• Place the sensor
(B)
back into the frame
(see fig-
ure 1)
. Make sure that the clips on the mounting
plate latch into the openings on the sensor.
5.2.3 Mounting on flush-mounted boxes
You can mount the temperature and humidity sensor on
flush-mounting/installation boxes using the holes
(G)
(see figure 5)
.
