63
Behaviour after power recovery
in processes mean that it may be reached in isolated
instances during start-up or initial installation of a sys-
tem. If the duty cycle is exceeded, this is indicated by
one long and one short red flash of the device LED, and
may manifest itself in the device temporarily working in-
correctly. The device starts working correctly again after
a short period (max. 1 hour).
10 Behaviour after power recovery
When the operating voltage is switched on (recov-
ery of mains voltage), the remote control checks its
components. If the test is completed without errors, the
remote control transmits a wireless telegram contain-
ing its status information. The LED will flash if an error
is detected during this check. This is repeated continu-
ously and the device does not perform its function.
To prevent all devices transmitting at the same time
when power is recovered, there is a random delay be-
fore the device transmits. During this time, the device
LED flashes (as in teach-in mode). If the delay is very
short, this flashing may be almost imperceptible.
