Start-up
Operation
12
13
box shows how much teach-in time remains.
•
Meanwhile, please activate the teach-in mode of your switch actua-
tor to teach-in as well. Therefore, press and hold the channel but-
ton
(A)
for at least 4 seconds. The device LED
(B)
will flash slowly
to indicate that teach-in mode is active.
> 4 s
•
After a short time, the newly taught-in device will appear in the in-
box of your software interface. The button „Inbox (x new devices)“
indicates how many new devices have been taught-in successfully.
•
If required, you can teach-in additional devices by repeating the
steps described above for each device.
• Now configure the newly taught-in devices in the inbox as de
-
scribed in section „Configuring newly taught-in devices“ .
Configuring newly taught-in devices
Once you have taught-in your switch actuator to the HomeMatic Cen-
tral Control Unit, it will be moved to the inbox. Here, you must configure
the device and its associated channels in order to make them avail-
able for operating and configuration tasks. Give the device a name
and assign the device/channels to a room. You can individually adjust
the switch on and off duration of the device as well as a delay time for
switching connected devices on and off.
Now you can use the „WebUI“ user interface to control your device,
configure it, connect it directly to other devices, or use it in central con
-
trol unit programs. Please refer to the HomeMatic WebUI Manual for
more details (you can find this in the „Downloads“ area of the website
www.homematic.com).
6
Operation
After teaching-in and configuring the device, you can control the switch
actuator e.g. with a connected remote control to switch on and off con-
nected loads (
see the following fig.
).
Lights on
Lights off
