HomeMatic 76793, Installation And Operating Manual, Page: 42 / 48

42
If the device is in teach mode, hold the (first)
channel button pressed down for at least 4 seconds.
The actuator reset is indicated by the device LED
flashing quickly.
10 Device LED feedback messages
10.1 Flash codes
Different actuator states are indicated by the
channel LED/channel LEDs flashing:
Slow flashing Teach mode
Fast flashing Reset
One long, x-short
(depends on the type
of error) Error
Note: Only one LED exists for both channels
for radio-controlled switch actuator 2
channel. The respective flash code appears as soon
as a channel is in the corresponding status.