54
55
Restore factory settings
Maintenance and cleaning
6x long red
flashing
Device
defective
Please see your app
for error message or
contact your retailer.
1x orange and
1 x green
lighting
Test display
Once the test display
has stopped, you can
continue.
8
Restore factory settings
The factory settings of the device can be restored.
If you do this, you will lose all your settings.
To restore the factory settings of the switch actuator and
meter, please proceed as follows:
• Remove the rocker (if necessary).
• Press and hold down the system button
(A)
for 4 s
with a pointed object (e.g. a pen) until the LED will
start flashing orange quickly
(see figure 7)
.
• Release the system button again.
• Press and hold down the system button again for
4 s, until the status LED lights up green.
• Release the system button to finish the procedure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.
9
Maintenance and cleaning
The product does not require any maintenance.
Enlist the help of an expert to carry out any main-
tenance or repairs.
Clean the device using a soft, lint-free cloth that is
clean and dry. You may dampen the cloth a little
with lukewarm water in order to remove more
stubborn marks. Make sure that no moisture will
ingress into the housing. Do not use any deter-
gents containing solvents, as they could corrode
the plastic housing and label.
10
General information about radio
operation
Radio transmission is performed on a non-exclusive
transmission path, which means that there is a possibil-
ity of interference occurring. Interference can also be
caused by switching operations, electrical motors or de-
fective electrical devices.
The range of transmission within buildings can differ
greatly from that available in the open air. Besides
the transmitting power and the reception charac-
teristics of the receiver, environmental factors such
as humidity in the vicinity have an important role to
play, as do on-site structural/screening conditions.
Summary of Contents for HmIP-BSM
Page 3: ...2 3 4 5 ...