Page 14
Insert the end of the new line into the hole in the
upper threaded area of the spool.
Wind the line counterclockwise around the spool
following arrows on spool.
Do not overfill.
NOTE:
After winding the line, there should be about
6 in. (152 mm) between the wound line and the
outside edge of the spool.
Secure the line temporarily by pushing it into one of
the slotted tabs on the spool.
Repeat the process for the lower threaded area of
the spool, winding the line clockwise and securing it
in the slotted tab opposite the first secured line.
Insert the lines into the eyelets in the trimmer head.
Place the spool on the drive shaft.
NOTE:
To install the spool, you may need to rotate it
slightly.
NOTE:
If the line should tangle or break at the
eyelets, remove the spool, refeed the line through
the eyelets, and reassemble the spool on the
trimmer.
Release the lines from the tabs by sharply pulling
each line while pushing down on the spool.
Push down on the spool to reveal the threads on the
drive shaft.
Place the retaining cap on the threads inside the
drive shaft.
Secure the retaining cap by turning it clockwise.
WARNING:
An improperly installed retaining cap or spool could
fly off the trimmer. Contact with a thrown retaining
cap or spool could cause personal injury.
REPLACING THE SPOOL
See Figure 14.
The spool may wear during normal use of the line
advance feature and may require occasional
replacement. Replacement spools are available through
your local retailer.
Release the trigger.
Unplug the trimmer.
WARNING:
Make sure the trimmer head stops rotating. Contact
with a rotating trimmer head could cause personal
injury.
Remove the retaining cap by turning it counterclock-
wise.
Remove the empty spool.
Fig. 14
MAINTENANCE
Clean the trimmer head thoroughly. Inspect the
trimmer head for any damaged or worn parts.
Hold the spool so that its tabbed side is positioned
upward.
NOTE:
On the new spool, the ends of the lines are
secured in slots on tabs. Release the line from the
tabs, unwind approximately six inches of line, and
re-secure the lines in the tabs.
Insert the lines on the new spool into the eyelets in
the trimmer head.
Place the spool on the drive shaft.
NOTE:
To install the spool, you may need to rotate it
slightly.
NOTE:
If the line should tangle or break at the
eyelets, remove the spool, refeed the line through
the eyelets, and reassemble the spool on the
trimmer.
Release the lines from the tabs by sharply pulling
each line while pushing down on the spool.
Push down on the spool to reveal the drive shaft.
Place the retaining cap on the drive shaft.
Secure the retaining cap by turning it clockwise.
TRIMMER
HEAD
SPOOL
DRIVE
SHAFT