D. INSTALLATION
C. COMPONENTS
Stopper
Sink Flange
Protector Ring
Mount Ring
Splash Guard
End Bell
(Electrical Connections)
Screw Clamp
Dishwasher
Discharge Inlet
Drain
Housing
Components
Lower Shell
Rubber Gasket
Fig 2.3 3-Bolt Mount System
Fig 2.1 3-Bolt Mount System
Fig 2.2 Elbow
Outlet Gasket
Built in Air Switch
(For built in Air Switch model only)
3-Bolt Mount System
Ring Assembly
Protector Ring
Rubber Gasket
Mount Ring
Screws
Sink Flange
Power Cord
Reset Button
INSTALLATION OF MOUNT SYSTEM
a. Disassemble the 3-bolt mount system ,
by turning the sink flange until the
protrusions align with the notches in
the mount ring and allow you to pull
the sink flange up and out. (See 1A)
b. Unpack the 3 mount screws and
screw them half way through the
mount ring. (See 1B)
3-Bolt Mount System
Read completely before starting
Pay close attention to the order of
mount assembly parts, as they have
been correctly assembled by the
factory. (See Fig 2.1, Fig 2.2 and Fig 2.3
Note:
The sequence of these parts as
they are stacked and refer to 1A
to identify each part.
1A
Protrusion
Note:
3-Bolt
Mount
System
