EN
27
VI ASSEMBLY
Before first use of the juicer:
– read and understand the contents of this manual,
– remove all the device components from the packaging and check them,
– make sure that the components are not damaged,
– clean the components that have contact with food,
– assemble the device.
ASSEMBLY INSTRUCTIONS (Illus. B,C)
– check that the rubber insert (8a) on the bottom of the container (6) is retracted (Illus. B),
– place the juice container (6) on the device body (11) and turn to the right (Illus. C1),
– insert the following components in a sequence into the juice container (6): filter base (5),
selected filter (4) and auger (3)(Illus. C2), make sure that the components are installed
properly (Illus. C3),
–the
▼
mark on the filter (4) should match the
▲
mark on the juice container (6) (Illus. C4),
– place the jugs (13, 14) below the outlets (7, 8),
– place the cover and turn to the right (2) (Illus. C5),
– insert the plunger (1) into the feed chute in the cover (2),
– connect the cable to the power grid (Illus. C6).
ASSEMBLY (instructional video) available at:
https://www.youtube.com/watch?v=BftgJBhng8c
TIP
If the auger is not installed properly, it won't be possible to close the cover. Check that
the auger is placed in the juice container in a stable manner (turn and force the auger into
place).
ESSENCE juicer has a built-in micro-switch (9) which acts as a safety block. This function
prevents turning on the device if it wasn't properly assembled.
