10
11
PROBLEM
CAUSE
SOLUTION
There is no steam
Steamer not plugged in
Plug into electrical outlet
ON/OFF switch not in
“ON” position
Remove the steam nozzle and hang on door
hook. Push the switch to the “ON” position.
Switch will illuminate.
Water tank is low or
empty
Check water tank to be sure it is full. See Filling
the Water Tank on page 5.
The hose is kinked
Be sure the steam hose is fully extended.
There is low or
intermittent steam
Mineral build-up
Follow the Removing Mineral Build-Up procedure
on page 9.
Water tank is low
Check water tank to be sure it is full. See Filling
the Water Tank on page 5.
Water runs through
the steam holes in the
nozzle
Condensation in steam
hose
Hold the hose vertically to allow the water to run
back into the water tank.
The steam hose and
nozzle are not being
used in a a vertical
position
Hold the hose vertically to allow the water to run
back into the water tank.
Nozzle gurgles
Condensation in steam
hose
Hold the hose vertically to allow the water to run
back into the water tank.
The steamer takes a
long time to heat
Mineral build-up
Follow the Removing Mineral Build-Up procedure
on page 9
The water tank is filled
above the fill line
Unplug the steamer, allow it to cool for 30
minutes, remove the steam hose and empty the
water water tank to the maximum fill line.
Problem Solving
