6
7
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Moving massage
mechanism
With L.E.D. illumination
(glows red when heat is activated)
The actual product materials and fabrics
may vary from the picture shown.
NOTE: When “POWER” button is pressed for first-time use, the moving mechanism will
automatically move to the lowest position before starting a massage program. After initial use,
mechanism will always park at lowest position. See note below regarding parking.
NOTE: The moving massage mechanism always “parks” or finishes in its lowest position. It
will continue to this position after the power has been turned off. If the electrical supply is
interrupted, when power is restored, the mechanism will “park” or move to its lowest position.
Summary of Contents for MCS-385H-2
Page 12: ......
