HOMEDICS
meˉ
12
GB
The face adaptor has been designed to accommodate smaller and more delicate
treatment areas on the face . It delivers energy in single pulse mode at the desired
energy level .
The face adaptor can be either included in this package (configurations vary) or
purchased separately as an accessory .
Facial Skin tones
Make sure to perform a skin sensitivity test before you start your treatment (check the
user guide for more info).
1.
Clean your skin and remove the hair on the surface of the skin . You may use
tweezers, wax, shaver, etc. Do not use the mē epilator accessory on your face as it
was not designed for facial use .
2.
Use a white eyeliner to conceal areas that should not be treated such as the edges
of your lips and facial moles .
3.
Choose a broad ambient light environment .
4.
Turn on your mē device and select the first elōs level on the base unit, which is Low.
Put on the provided eye goggles or sunglasses . If you have a face adaptor, remove
the accessory protective cap and connect the face adaptor . The face adaptor will
allow system to emit only single pulses with the desired energy level .
5.
Press the elōs cartridge activation button on the applicator to turn on the
applicator .
6.
Gently position the applicator on the area you want to treat. Press again the elōs
cartridge activation button to apply a single pulse . If you feel comfortable, you may
change the elōs level from Low to Med or High.
7.
Reposition the applicator on the next area to be treated and press again the elōs
cartridge activation button to apply another pulse . Repeat these previous steps until
you have covered the entire facial area . Wait at least 10 seconds before you treat
over the same spot .
Note: Start with LOW elōs level, if you feel comfortable, you may increase the elōs level for better
results.
