Snooze Operation
1. Press the SNOOZE/NAP BUTTON (Fig. 1) on the unit while the alarm is
sounding. The alarm will go off temporarily and will go on again in
9 minutes. You may use this feature until you turn the alarm off.
Note: To turn off the snooze function prior to the alarm activating,
press the POWER BUTTON twice. The alarm will come on again
the next day at the same time.
Nap Operation
The NAP TIMER FUNCTION will wake you after a nap of 15, 30, 45, or 60
minutes without the need to change your regular Alarm 1 or Alarm 2 settings.
1. If the system is playing, press the POWER BUTTON (Fig. 1) to off.
2. Toggle through the SNOOZE/NAP BUTTON (Fig. 1) until the
corresponding time is shown on the LCD display.
3. Toggle through the AL MODE BUTTON (Fig. 1) until the WAKE MODE
ICON appears on the right side of the LCD to indicate the wake mode
of your choice: iPod, radio, sounds or beep (Fig. 2).
Note: To wake to iPod/iPhone, your iPod/iPhone must be properly
docked in the unit, or alarm will default to beep wake mode.
4. The alarm will sound to wake you up after the selected amount of
minutes have passed.
5. To cancel the NAP TIMER, press the SNOOZE/NAP BUTTON, until “OFF”
appears on the LCD display to indicate NAP function is disabled.
Dimmer Control
1. Press the DIMMER HI/LO BUTTON (Fig. 4) located on the back of the
unit to adjust the backlight intensity of the LCD display.
1 6
1 7
Using the Projection Feature
1. To turn on the projection feature, press the PROJECTOR ON/OFF
BUTTON (Fig. 4) located on the back of the unit. The time is now
projected on the wall or ceiling.
2. The angle of the projector can be adjusted to angle on the ceiling or wall by
moving the PROJECTOR TUBE (Fig. 4) forward or backward.
3. To turn the angle of the time that appears on the wall of ceiling,
rotate the TIME ROTATION KNOB (Fig. 4) until you have reached your
desired result.
Note: The TIME ROTATION KNOB will rotate up to 350 degrees.
4. To focus the time on the wall or ceiling rotate the FOCUS KNOB (Fig. 4) until
you have reached your desired result.
Using the Remote Control
Install/Replace Remote Control Battery
One lithium battery is packaged with the remote. To begin using the remote,
install the battery provided. When the remote stops operating or when the
operating range is reduced, replace the battery with a new one.
1. Open the battery compartment cover located on the back of the remote.
2. Remove old battery from remote control.
3. Insert one 3-volt lithium battery, Model #: CR2025, checking that
positive polarity faces towards you.
4. Close the compartment cover.