HoMedics HST-200-EU, Manual

Page: 6 / 40

GB I 6
SMALL GEL PAD CONNECTION
Operation
1. Connect the electric wire to the electrode gel pad with the snap button.
2. Connect the electric wire to the output jack of the device
3. Remove the protective gel pad layer and stick pad on desired area. (Remember to keep the protecting film for storage of the gel pad).
4. Push “ON/HI” button to turn on the device. To switch the device off, press the “OFF/LO” button.
5. Press the “MODE” button repeatedly to select preferred programme. There are 6 different programs for selection - Sculpt, Wave, Ripple, Pulse,
Kneading and Tapping. An arrow will point to the mode selected.
6. Push the “ON/HI” or “OFF/LO” button to carefully increase or decrease the intensity. The LCD display will show the intensity level which you have
selected. (This device will only turn on when connected to the gel pads which are in contact with the skin) .
7. There is a tingling sensation prior to the muscle contracting. Once the muscle is contracting the tingling will subside. Adjust the intensity
according to your comfort level. You should feel a strong but comfortable contraction of the muscles. During toning, if mode button is pressed to
change the toning pattern, the intensity is automatically reset to “1”.
8. Press “TIME” button to set the timer for auto-off, which available 5/10/15/20/25/30 minutes.
NOTE: when using the belt and pads simultaneously, if you disconnect the belt or pads without switching off you will experience an increase in
power. If you find the stimulation to be uncomfortable then turn the level down.
Toning Programs
Sculpt
- Short, deep bursts for effective toning of the upper arms
Wave - Replicates crunches, ideal for toning the stomach
Ripple - High intensity for shaping thighs and bottom
Pulse - Pulsing sensation ideal for problem areas around the hips and waist.
Kneading - Deep tissue massage relaxes muscles
Tapping - Eases all over muscular tension and stress.
Auto off Functions
When the conductive area of the belt does not touch the skin, the intensity can only be set up to “1”.
If the belt is removed during use, the intensity is automatically reset to “1”.
If the attachment is not placed back into contact with the skin, the unit will turn off after 30 seconds. The unit has an auto-timer. It will shut off after
10 minutes of massage. If you change the massage mode within the 10 minutes, the timer will count-down from the original leftover time.
1. 2. 3. 4.
5. 6. 7. 8.
IB-HST200EU-1117-06.qxp_Layout 1 09/11/2017 15:09 Page 6