9. Hold the slate wall in between the U-shaped clips, aligning the holes.
Then, slide the long screws through the holes. Secure with the corre-
sponding nuts on the back. (Fig. 9)
10. Fill the base with clean water until the water level is 3/4” below the
lowest edge of the base. (Fig. 10)
11. Attach the A/C adaptor jack to the base power cord. (Fig. 1)
5. Insert the small end of the copper tube into the plastic tube
(the end without the black connector). (Fig. 5)
6. Insert the end of the plastic tube with the black connector into the pump.
(Fig. 6)
7. Then place the platform on the base so it sits level. Lead the cord out
through the cord slot located on the upper backside of the base. (Fig 7.)
8. Slide the U-shaped clips over the copper bar, one on either side of the
vertical pole. (Fig. 8)
6
7
BLACK
CONNECTOR
PLATFORM
PLASTIC
TUBE
SMALL END OF
COPPER TUBE
BLACK
CONNECTOR
PLASTIC
TUBE
SMALL END OF
COPPER TUBE
BASE
PUMP
PLATFORM
CORD
CORD
SLOT
COPPER TUBE
PLATFORM
U-SHAPED
CLIPS
SLATE WALL
VERTICAL POLE
NUT
U-SHAPED
CLIPS
SCREWS
LONG
SLATE WALL
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
12. Plug the cord into 120V household outlet. The fountain is controlled by
a switch located on the power cord. If pump does not operate, rotate
in-line switch once to turn “on” and once to turn “off”.
Note: Ensure that the electrical cord loops below the electrical outlet to
form a “Drip Loop”. This will prevent water from running down the
electrical cord into the electrical outlet. (Fig. 11)
WFL-SLFA_6.qxd 8/26/05 11:16 AM Page 7
