HoMedics EnviraScape WF-ZEN Instruction Manual And Warranty Download Page 3

Page: 3 / 8

• The electrical cord of this product cannot be replaced. If it sustains

damage, you must stop using the appliance immediately and
return it to the HoMedics Service Center for examination and
repair. (See the warranty section for HoMedics address).

• Disconnect the appliance from the electrical outlet before putting

hands into water.

Assembly and Instructions for Use

1. Remove all contents from packaging and inspect to make sure

all components have been received (Fig. 1):
• Base with attached electrical cord and water pump
• Fountain top
• A/C Adapter

2. Wipe any dust off the interior and exterior of the base and top.
3. Familiarize yourself with the pump. The pump speed is

controlled by the dial located at the front of the pump. The speed
is indicated by a “-” and “+”. To increase the speed, move the
dial downward in the direction of the “+”. At its highest speed
level, the dial will cease to move any further. To decrease the
pump speed, move the dial upward toward the “-”. Similarly, at
its lowest speed, the dial will cease to move any further (Fig. 2).

NOTE

: It is recommended the pump be set at its

highest speed during assembly and later adjusted
to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.

4. Place the fountain base on a sturdy, level surface

in the desired location, ensuring its electrical cord
will sufficiently reach an electrical outlet. Once
assembled, the fountain may be difficult to move
due to splashing. Once in the desired location,
lead the power cord attached to the base through
the notch at the bottom of the base to ensure the
base sits level without wobbling. Attach the A/C
adapter jack to the base power cord. Do NOT plug
in at this time (Fig. 3).

5. Add clean water to the base until the water level

is 1/2" to 3/4" below the rim.

6. Connect the PVC tube to the pump, adjust the

pump speed and place the fountain top on the
base (Fig. 4).

7. Place the fountain top on to the base.
8. Plug the A/C adapter into a 120V household outlet.

The fountain is controlled by the switch located on
the power cord. If pump doesn’t operate, rotate
in-line switch once to turn “ON” and once more to
turn “OFF”.

NOTE

: If you can hear the pump gurgling or making

sounds, you have not added enough water to cover
(submerge) the pump.

9. It will be necessary to add water occasionally due

to evaporation.

NOTE

: Always add water when fountain is “OFF”

to avoid overflow.

Figure 3

PVC Tube

Figure 4

Figure 2