Minimum Water Level
Flow Control Valve
(+) faster water
output
(-) slower water
output
Attention:
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
Figure 1
Figure 5
Folded
Bracket
Base
4. Fold stand to create the bracket (Fig. 3) and then insert bracket
into the grooves located inside the base. (Fig. 4)
5. Place the floor cover over the bracket so it rests on the tabs of the
bracket. (Fig. 5)
6. Insert the large end of the connector tube into the round opening on the
fountain top. (Fig. 6)
7. Insert the small end of the connector tube into the round opening on the
pump. (Fig. 6)
8. Place fountain top on the bracket so it sits level.
Note: The support bars (Fig. 2) on the underside of the fountain top will
fit inside the bracket in order to make the unit secure & level.
9. Remove protectors from glass tiers located on the fountain top.
Note: You can adjust the glass by twisting each tier separately.
10. Fill the base with clean water until the water level is even with the
bottom of the floor cover.
11. Arrange glass stones on the floor cover for decoration
12. Plug the cord into 120V household outlet. The fountain is controlled by
the switch located on the power cord. If pump doesn’t operate, rotate
in-line switch once to turn “on” and once to turn “off”.
Note: Ensure that the electrical cord loops below the electrical outlet
form a “Drip Loop”. This will prevent water from running down the
cord into the electrical outlet (Fig 8).
Figure 6
Large End of
Connector Tube
Fountain Top
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by
the switch located at the front of the pump. The speed is indicated by
a plus (+) and minus (-) sign. To increase the speed, move the switch
slowly downward in the direction of the plus sign. You will hear a click
as the switch moves to each speed level. At its highest speed level,
the switch will cease to move any further. To decrease the pump
speed, move the switch upward toward the minus sign. Similarly, at its
lowest speed, the switch will cease to move any further (Fig 1).
NOTE: It is recommended the pump be set at its highest speed dur-
ing assembly and later adjusted to a lower setting if desired. Be sure
to unplug the pump before adjusting the speed setting.
3. Lead the cord through the cord slot (Fig. 2) on the bottom of the
base. This will ensure that the unit is balanced when placed on a flat
surface. Attach the A/C adaptor jack to the base power cord. (Fig. 2)
DO NOT PLUG INTO ELECTRICAL OUTLET AT THIS TIME.
4
5
Figure 2
Tab
Figure 3
Figure 4
Stand
Folded Bracket
Grooves
Base
Fountain Top
Floor Cover
Bracket
Water
Pump
Switch
Adaptor
Base
Small End of
Connector Tube
Pump
Stones
Support Bars
Connector Tube
Tab
Cord Slot
Floor
Cover
WFG-STEPS.doc 7/27/05 9:57 AM Page 5
