CAUTION CONTINUED
• The electrical cord of this product cannot be replaced. If it
sustains damage, you must stop using this product immedi-
ately and return it to the HoMedics Service Center for repair.
(See the warranty section for HoMedics address.)
• Disconnect the appliance from outlet before putting hands
into water.
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is con-
trolled by the switch located at the front of the pump. The
speed is indicated by a plus (+) and minus (-) sign. To
increase the speed, move the switch slowly downward in
the direction of the plus sign. You will hear a click as the
switch moves to each speed level. At its highest speed level,
the switch will cease to move any further. To decrease the
pump speed, move the switch upward toward the minus
sign. Similarly, at its lowest speed, the switch will cease to
move any further (Fig 11). NOTE: It is recommended the
pump be set at its highest speed during assembly and later
adjusted to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
4
5
3. Lead the cord through the cord slot on
the bottom of the base. This will
ensure that the unit is balanced when
placed on a flat surface. Attach the
A/C adaptor jack to the base power
cord. DO NOT plug into outlet at this
time (Fig. 1).
4. Slide the small waterproof light
attached at the pump into the rubber
plug of the plastic light tube at the
underside of large leaf (Fig.2).
5. Connect the PVC tube over the
water supply tube located at the
underside of large leaf, then insert
the small end of the PVC tube into
the pump outlet (Fig. 2).
6. Attach the three legs to the slots
located at the underside of the large
leaf. Insert other end of leg into slot
located inside of base.
Align the mark “
h
”at the underside of
large leaf with the mark “
h
” at the
edge of base (Fig. 3).
NOTE: Only one leg requires slot,
other two legs sit flush on
bottom surface of base.
7. Place middle leaf on pillar of large leaf,
then place small leaf on top (Fig. 4).
8. Add approx. 33oz clean water into
the base. The water level should be
even with the watermark. Place
stones on the large, middle, small
leaf and base for decoration (Fig. 5).
NOTE: To achieve the best water
movement, adjust middle and small
leaf by rotating slightly.
9. Plug the cord into 120V household
outlet. The fountain is controlled by the
switch located on the power cord. If
pump doesn’t operate, rotate in-line
switch once to turn “on” and once more
to turn “off”. NOTE: Ensure that the
electrical cord loops below the electrical
outlet to form a ‘Drip Loop’ (Fig. 6). This
will prevent water from running down
the cord into the electrical outlet.
Figure 2
Figure 3
Figure 5
Figure 1
Figure 4
Figure 6
Small Leaf
Middle Leaf
Large Leaf
Stones
PVC Tube
Leg
Watermark
Base
Waterproof
Light
Leg
Pump
Cord Slot
Adaptor
Switch
Power Cord
Slot
Slot
Pump Outlet
Slot
Water Supply
Tube
PVC Tube
Pump
Plastic
Light Tube
Waterproof Light
Slot
Slot
Mark on
Large
Leaf
Mark on
Edge of
Base
Leg
Small
Leaf
Middle
Leaf
Pillar
Large
Leaf
Stones
Water
Watermark
Drip
Loop
Slot
