2. Assemble Chair Base:
• Attach both crossbars (figure 2) to the right hand armrest, matching
corresponding numbers, and insert large bolts. Tighten partially with
Allen wrench.
• Attach both crossbars to left side armrest, matching the corresponding
letters, and insert large bolts (figure 3). Tighten partially
with the Allen wrench. Stand base upright.
3. Attach Back Frame to Base:
• Slide the back of the chair into the frame with the straps facing the
chair (figure 4).
• Align the back by inserting the large bolts into the frame.
• Place a washer and nut over each bolt to secure the Back
Frame to the Chair Base. Use open end wrench to tighten partially
(figures 5A and 5B).
4
Figure 2
Figure 5A
Figure 3
Figure 4
5
Important Notice:
If you experience any
type of distortion or
interference to radio
or television reception
when turning the unit
to the ON position,
immediately turn
the unit off. Wait a
few seconds before
turning the unit on and
distortion/interference
should be eliminated.
Figure 1
Assembly Instructions
1. Carefully remove all contents from the packaging and inspect the
product to make sure all components of the recliner are present.
These should include (figure 1):
• Right side armrest with hand control pocket (A)
• Left side armrest (B)
• Crossbars (C) & (D)
• Cup holder (E)
• Back and leg frames with attached slip covers (F) (G)
• Small nuts and washers (8) (H)
• Large bolts (8) (I)
• Allen wrench (J1)
• Open end wrench (J2)
• Massage mat with attached hand control (K)
• Detachable headrest (L)
• AC adaptor (M)
Figure 5B
G
B
H
D
C
F
E
H
I
J1
J2
A
K
L
M
