HOMEDEPOT MONTGOMERY II, Use And Care Manual, Page: 6 / 12

6
NOTE : Y ou may need a longer downrod to maintain proper
blade clearance when installing on a steep, sloped ceiling.
The maximum angle allowable is 18° from horizontal.
Figure 7
Installing the mounting bracket
3
Figure 6
Outlet Box
A
B
Round Hole
Bayonet
Slot
Canopy
Screw
Hook
A
Pass the 120-volt supply wires through the center hole in
the mounting bracket (A) as shown in Figure 6.
Tighten the two mounting screws securely and carefully
lift the fan assembly up to the mounting bracket (A).
Attach the mounting bracket (A) on the electrical box by
sliding the mounting bracket (A) over the screws provided
with the outlet box. Make sure the mounting bracket (A) is
level. You may need to insert additional washers (not
provided) between the outlet box and the mounting
bracket (A) to make it level. Note the flat side of the
mounting bracket (A) should be toward the electrical box.
REMEMBER to turn off the power at the breaker box. Follow the
steps below to hang your fan properly.
Before making any electrical connections, hook one of the
screw holes on the ceiling canopy (B) with the hook on the
mounting bracket (A) so it hangs (Figure 7).
RDB9144-MW/BN/ORB
Installation (continued)