Customer Helpline
03448012949
12
23
26
26
24
a
a
20
13
22
A
B
B2
B3
C
D
E
F2
F1
G
I
J
K
L
H
B1
25
b
a
b
c
d
e
21
a
f
a
c
M
N
O
P
the workpiece. (Locate the clamp vice at right side when you make bevel cutting.)
Do not operate the saw without clamping the workpiece.
Make sure that the work clamp securing screws are tightened.
1. To make a cut
1. When boxed or during storage, transportation, the saw head is locked in the down
position. To release the head ready for operation, apply downward pressure and pull out the
lock pin (20).
2. Connect the machine to power outlet ensure that the mains cable is clear of the blade and
base plate.
3. Position the material to be cut on the machine bed, ensure it is firmly held so that it will not
move during cutting.
Ensure that the rotary table locking knob (13) and bevel lock knob (22) are tightened before
cutting.
4. Press the trigger switch and allow the saw blade to run up the speed.
5. Still holding in the trigger switch, press the safety release lever (16) towards the handle. It
will then be possible to push the saw head down by the handle.
6. Continue to move the saw head down smoothly and make the cut exerting only gentle
pressure on the downward stroke, letting the saw do the work.
2. Mitre cuts (See Fig. E)
A mitre cut is made at 0
O
bevel and any mitre angle in the range from 45° left to 45° right.
Release the rotary table locking knob (13). Move the saw to the desired angle by twisting so
that the table turns. Set at the desired angle, and tighten the rotary table locking knob. Make
your cut.
Operation Instructions
Operation
Assembly (continued)
