Home URC 1, Instruction Manual

Page: 4 / 32

remote control will switch off. This may take a
few minutes.
Reading a selected code
If you fi nd the proper code with the quick search
function, it is advisable to note it down to make its
reselection easier. The number of the fl ashes the
LED makes is equal to the fi rst, second, third and
fourth digits of the four-digit number respectively.
Press and hold the SET button and, while doing so,
press a number button (1-2-3-4) to fi nd out the val-
ues of the various digits. Then release both buttons
and count the fl ashes.
For example, if the selected code is 0261:
1. SET + ”1”: 0 fl ash
2. SET + “2”: 2 fl ashes
3. SET + “3”: 6 fl ashes
4. SET + “4”: 1 fl ash
note: no fl ash means zero
Battery replacement
The batteries need to be replaced if the LED
dims out you experience a drop in the range. The
battery compartment cover may be removed
by sliding it in the direction of the arrow. Insert
two AA 1.5 V batteries according to specifi ed
polarity pattern. It is advisable to use long life
(alkaline) batteries. Rechargeable batteries are not
recommended. Do not mix batteries from
different manufacturers.
Codes selected earlier are retained in the
memory while batteries are being replaced.
Pressing any of the buttons while replacing the
batteries may result in data loss!
Warning
Do not expose the remote control to direct heat,
sunlight, dust, steam or shock.
Remove dust regularly using a soft cloth.
Make sure that no liquid substance is spilt on the
keypad.
Technical data
system: . . . . . . . . . . . . . . pre-programmed, infra red
range: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-7 m
power supply: . . . . . . . . . . . . . . . . . . . . 2 x AA (1,5 V)
dimensions: . . . . . . . . . . . . . . . . . 185 x 44 x 18 mm
4