Home URC 1, Instruction Manual

Page: 3 / 32

the button corresponding to the type of
device you want to control: TV: television / VCR:
video cassette recorder / AUX: stereo system
/ SAT: satellite receiver
3. Release all buttons as soon as the red LED
located next to the SET button goes on.
4. Press the SET button again and then release it.
The LED will start fl ashing, which shows that the
remote control unit is in quick search mode.
5. Direct the remote control toward the
device you want to operate and press the
POWER button (if you are using a VCR, press
PLAY). Watch the reaction, whether the TV
is turned off or the VCR starts playing the
cassette.** If the device reacts, test the other
buttons as well. If nothing happens, press
the POWER again and again until the device
switches off. The remote control sends a signal
corresponding to the next brand code each time
you press the button.
*note: Due to the versatility of the product
and the constantly increasing number of tele-
communication devices in the world market, it
is impossible to prepare an up-to-date list of all
manufacturers, brands and product types compatible
with the remote control.
As manufacturers often take over technologies from
one another, and, in addition, the same manufacturer may
use different codes in its various product lines, there
may be several overlaps in operating codes. In some
cases, several codes may operate the device (even
codes assigned to other manufacturers), the only
difference being that one code provides access to more
functions than the others, or sometimes the functions of
the buttons may get mixed up.
Therefore, it is advisable to try all codes that operate the
device and then choose the one that provides highest
functionality.
**note: some devices react to signals slower,
so make sure you wait for enough time between
pressing the POWER button again and again. All
buttons function properly in code search mode, so
they you can test them before moving on to the next
code. Pressing the SET button changes the search
direction.
You can exit the quick search mode by pressing any
device selection button (e.g. TV) or by not pressing any
button for 30 seconds.
Automatic quick search
This function automatically runs through all codes.
You may as well put the remote control on your
coffee table and wait for your device to react.
1. Turn on manually the device you want to
operate.
2. Press the appropriate device selection
button (e.g. TV)
3. Press and hold the SET button and, while
doing so, press the POWER button. The LED will
go on after 3 seconds
4. Direct the remote control toward the device and
release all buttons. The remote control will start
running through the codes automatically.
5. If the device reacts to any of the codes, you
can stop the automatic process by pressing
any of the buttons. After having run through
all the codes, the LED will go off and the
3