* For easy installation, select an existing light with a wall switch for
replacement.
* For best performance, mount the fixture about 8 ft. (2.4 m) above the
ground.
Note: If fixture is mounted higher than 8 ft. (2.4 m), aiming the sensor
down will reduce coverage distance.
* For under eave installation, the sensor head must be rotated
as shown in the next two steps for proper operation and to
avoid the risk of electrical shock.
1. Swing the sensor head towards the clamp screw joint.
2. Then rotate the sensor head clockwise 180° so the controls
face down.
Note: If the sensor pops out of the ball joint, loosen the clamp
screw and push the sensor back into the ball joint. Tighten
the clamp screw when done.
(888) 782-5618
HOW TO INSTALL
OPERATION
LED Motion Activated Security Light
Model No. ES00735V
s e c u r i t y
www.homezonesecurity.com
Figure 1& Figure 2: Pre-installation
WARNING: Turn power off at circuit breaker or fuse.
1.Remove the existing light fixture.
2.Install the mounting strap as shown using two screws that fit your
junction box.
3.The plastic hanger can be used to hold the fixture while wiring. The
small end of the plastic hanger can be threaded through the hole in
the center of the cover plate. The small end then goes into one of
the slots on the mounting strap.
4.Route the light control’s wires through the large gasket holes.
5.Twist the junction box wires and fixture wires together as shown.
Secure with wire connectors.
Figure 3: Wire the Light Control
1. Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1 1/2 minute warm up period before it will detect
motion. When first turned on, wait 1 1/2 minutes.
2. Turn the RANGE control to the medium position (halfway between MIN
and MAX) and the ON-TIME control to the TEST position. (Figure 4)
Avoid aiming the control at: (Figure 5)
• Objects that change temperature rapidly, such as heating vents and air
conditioners. These heat sources could cause false triggering.
• Areas where pets or traffic may trigger the control.
• Nearby large, light-colored objects reflecting light may trigger the shut-off
feature. Do not point other lights at the sensor.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
