Item# A35BA-1
4 Shelf Wire Shelving Rack
Assembly Instructions
Questions, Problems, Missing Parts?
Before returning to your retailer, CALL OUR CUSTOMER SERVICE DEPARTMENT at
1-866-375-7994, 9 a.m. - 5 p.m. EST. MONDAY- FRIDAY. E-Mail:[email protected]
Tools Required For Assembly
Parts List (B)
No tools required for assembly. A (4) Shelf
Helpful - Rubber Mallet
B (16) Plastic Tapered Lock Sets + (2) sets extra
C (4) Top Poles
(with pole connector & caps Pre-installed)
Connector
Cap
D (4) Bottom Poles
(with levelers pre-installed)
Leveling Foot
Note: Black plastic discs used for packing only - Discard
SPECIAL WARNINGS
Assemble the item on a soft, non-abrasive surface, such as carpeting, to avoid scratching the finish.
Use care when handling. May require two adults for safe assembly.
CARE AND MAINTENANCE
Periodically check and make sure that all components are in their proper position, are free from damage and that all connectors are tight.
ASSEMBLY INSTRUCTIONS Estimated Assembly Time: Approximately 20 minutes
08/21/12
Start with the bottom shelf and choose the desired height.
Note: Bottom shelf should be no more than six inches from the floor.
Step 1
Snap the two halves of a plastic tapered lock (B) with the tapered
end facing up, at the desired height on bottom pole (D). Be sure to
install the plastic tapered locks (B) at the same height.
Pay close attention to using the same groove lines
on all four poles.
Step 2
Rest shelf (A) on its side on the floor (shelf lip facing down) and
slide the four bottom poles (D) (top pole end first) through the
holes on the corners of the shelf.
Step 3
Turn the unit upright and push the shelf firmly into place so the
shelf is resting on the plastic tapered locks (B).
Step 4
Install the 2nd shelf (A) repeating the instructions in step 1.
Install shelf on the poles and push the shelf firmly into place so the
shelf is resting on the plastic tapered lock (B)
3
4
D
B
1
A
D
D
D
D
2
