3. ATTACHING DISCHARGE ELBOW
A. Connect waste disposal elbow to the disposer (see 5A),
- Please note the direction of the gasket before removal.
- Remove the rubber gasket
- Fit the mounting over the elbow
- Replace the gasket the correct way as removed
- Secure the elbow to the disposer and secure it using the screws provided.
B. If you are connecting to a dishwasher, go to section 5. If not, connect bottom of the elbow by
tightening the slip nut (see 5B).make sure all plumbing connections are tight and in accordance with
all plumbing codes and ordinances. Run water and check for leaks
4. CONNECTING DISPOSER TO MOUNT ASSEMBLY
A. Line up disposer under mounting assembly. Guide hopper projections into mount ring slots. Turn
mount ring about 1/4” to right so that disposer is temporarily supported (see 6A).
B. Turn mount ring and disposer until disposer elbow lines up with trap (see 6B).
C. Turn mount ring to the right (counter-clockwise) until it reaches the locking position as shown (6D).
Hopper projections must be to extreme left of mounting slots (see 6C & 6D).
D. If mount ring is hard to turn, you may add a small amount of petroleum jelly or liquid soap to hopper
projections. Run water and check for leaks.
