7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Preparing for mounting
□
Remove the magnetic canopy bottom cover (JJ) from the canopy
(C) by pulling it off.
□
Loosen the two canopy screws (FF) located in the bottom of the
mounting bracket (A).
□
Turn the mounting bracket (A) counterclockwise and lift it up to
remove the mounting bracket from the canopy (C).
□
Connect the shorter lead wire (L) to the fan wires exiting the top of
the fan motor assembly (E) by connecting the molded adaptor plugs
together. Route the wires through the decorative motor collar cover
(D) and then the center of the canopy bottom cover (JJ).
□
Make sure the opening of canopy (C) is on top and insert the ball/
downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
1
NOTE:
The fan comes with 12 in. lead wires for use with
the provided 6 in. ball downrod assembly (B). If you wish
to use a longer downrod, attach the extension wire (K) to
the fan by connecting the molded adaptor plugs from the
extension wires to the adaptor plugs from the fan.
Assembling the fan
□
Loosen, but do not remove, the setscrew (KK) on the collar (PP) on
top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (PP),
and turning it clockwise until the holes at the bottom of the ball/
downrod assembly (B) align with the holes in the collar on top of
the fan-motor assembly (E).
□
Carefully insert the hanger pin (CC) through the holes in the collar
and ball/downrod assembly (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the ball/downrod assembly (B).
□
Insert the locking pin (DD) through the hole near the end of the
hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrew (KK) on the collar (PP) on top of the fan-
motor assembly (E).
WARNING:
Failure to properly install the locking
pin (DD) could result in the fan becoming loose and
possibly falling.
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew (KK)
must be completely tightened.
3
A
C
JJ
FF
C
JJ
D
E
KK
DD
CC
PP
B
C
JJ
B
E
D
L
NOTE:
The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
