7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for standard mounting
□
Loosen, but do not remove, the setscrews (LL) on the collar on
top of the fan-motor assembly (E).
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (AA) through the holes in the
collar and ball/downrod assembly (B). Be careful not to jam
the hanger pin (AA) against the wiring inside the ball/downrod
assembly (B).
□
Insert the locking pin (BB) through the hole near the end of the
hanger pin (AA) until it snaps into its locked position.
□
Re-tighten the setscrews (LL) on the collar on top of the fan-
motor assembly (E).
□
Remove the canopy bottom cover (JJ) from the canopy
(C) by turning the bottom cover counterclockwise until it
unlocks.
□
Loosen the two canopy screws (HH) located in the
bottom of the mounting bracket (A), and turn the canopy
counterclockwise to remove the mounting bracket (A)
from the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (JJ).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
3
1
WARNING:
Failure to properly install the locking
pin (BB) could result in the fan becoming loose and
possibly falling.
C
A
HH
JJ
C
D
E
JJ
B
C
D
E
JJ
B
BB
AA
LL
