7
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for mounting
□
Route the wires exiting the top of the fan motor
assembly (E) through the decorative motor collar
cover (D) and then the center of the canopy
bottom cover (FF).
□
Make sure the opening of the canopy (C) is on
top and insert the ball/downrod (B) through the
canopy (C).
□
Route the wires exiting the top of the fan motor
assembly (E) through the downrod as shown.
2
3
1
□
Loosen, but do not remove, the setscrew (JJ) on the collar (HH)
on top of the fan-motor assembly (E).
□
Install the downrod (B) by inserting it into the motor collar (HH),
and turning it clockwise until it is tight.
□
Re-tighten the setscrew (JJ) on the collar (HH) on top of the
fan-motor assembly (E).
NOTE:
This fan is equipped with a safety tab (EE).
Should the setscrew (JJ) ever become loose while
the fan is running in reverse, the safety tab (EE) will
engage and stop the fan from falling.
CAUTION:
To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(JJ) must be completely tightened.
C
B
FF
D
E
C
B
FF
D
E
JJ
HH
EE
A
GG
C
FF
NOTE:
The magnet is pre-attached on the canopy
bottom cover for you to remove and install easily.
□
Pull off the canopy bottom cover (FF) from the canopy (C).
□
Loosen the two canopy screws (GG) located in the
bottom of the mounting bracket (A), and turn the canopy
counterclockwise to remove the mounting bracket (A) from
the canopy (C).
