12
Assembly - Attaching the Light
Attaching the light kit fitter assembly
1
□
Remove one screw (LL) from the black bracket below fan
motor assembly (E), and loosen, but do not remove the
other two screws.
□
Connect the wires from the light kit fitter assembly (H) to
the wires from the fan motor assembly (E) by connecting
the molded adaptor plugs together. Carefully tuck all wires
and splices into the switch cup.
□
Push the light kit fitter assembly (H) up to the black
bracket so that the two loosened screw heads fit into
the keyhole slots. Turn the light kit fitter assembly (H)
clockwise to secure.
□
Re-install the screw (LL) that was removed in step 1.
□
Make sure all the screws are firmly tightened.
CAUTION:
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
Installing the glass bowl
2
□
Remove the finial nut (RR) and the hex nut (NN) from the
threaded nipple of the light kit fitter assembly (H).
□
Position the glass bowl (I) over the threaded nipple.
□
Re-install the hex nut (NN) to the threaded nipple to secure
the glass bowl (I) properly.
□
Re-install and tighten the finial nut (RR).
CAUTION:
Make sure the power is off before attaching or
removing the glass bowl.
WARNING:
Allow the glass bowl to cool completely before
removing.
WARNING:
To prevent breaking of the glass and to avoid
personal injury, hand tighten all parts in order. Do not use any
tools to tighten the nut or finial.
LL
E
H
E
I
NN
RR
