1
1
4
4
COMMAND_CLASS_SENSOR_MULTILEVEL
The RC-90BZ thermostat uses this command class to report the actual temperature.
COMMAND_CLASS_ASSOCIATION
Upon power up, allow 10 seconds for the RC-90BZ thermostat to initialize. After 10 seconds, a controller can
issue an Association Set, Remove, or Get command. The thermostat must be associated with a controller to
provide feedback.
COMMAND_CLASS_CONFIGURATION
Upon power up, allow 10 seconds for the RC-90BZ thermostat to initialize. After 10 seconds, a controller can
change individual register settings for the outdoor temperature. The Parameter Number is 67. The size of the
data is a 1 byte value. The Value is the temperature to which the register is set.
COMMAND_CLASS_THERMOSTAT_FAN_MODE
Upon power up, allow 10 seconds for the RC-90BZ thermostat to initialize. After 10 seconds, a controller can
set the fan mode, get the current fan mode, and get the fan modes supported by the thermostat.
COMMAND_CLASS_THERMOSTAT_FAN_STATE
Upon power up, allow 10 seconds for the RC-90BZ thermostat to initialize. After 10 seconds, a controller can
request the state of the fan.
COMMAND_CLASS_THERMOSTAT_OPERATING_STATE
Upon power up, allow 10 seconds for the RC-90BZ thermostat to initialize. After 10 seconds, a controller can
request the Operating State report.
COMMAND_CLASS_VERSION
Upon power up, allow 10 seconds for the RC-90BZ thermostat to initialize. After 10 seconds, a controller can
request a Version Report. This report includes information about the library type, protocol, version, and
application version from the device.
COMMAND_CLASS_MANUFACTURER_SPECIFIC
Upon power up, allow 10 seconds for the RC-90BZ thermostat to initialize. After 10 seconds, a controller can
request a Manufacturer Specific Info Report. This report will return the Manufacturer ID, Product Type, and
Product ID.
COMMAND_CLASS_SWITCH_BINARY
Upon power up, allow 10 seconds for the RC-90BZ thermostat to initialize. After 10 seconds, a controller can
turn on the Hold feature by sending a Binary Switch On command and turn off the Hold feature by sending a
Binary Switch Off command.
