Installation and Operation Manual
-‐ 6 -‐
INSTALLATION - Position of Mounting Bracket
The Integrated Rangehood is mounted to the rear of the overhead cupboard. Supplied with
the rangehood is a mounting bracket (Fig. 2)
Fig. 2
Prior to installation, check the measurement from the screw holes in the mounting bracket to
the base of the rangehood. Achieve this by placing the mounting bracket onto the rear of
the Integrated rangehood and measure from base of rangehood to the mid point of the
centre screw hole on the mounting bracket. This may vary slightly to the dimensions
mentioned in Fig. 3. and should be the one you use to ensure the base of the rangehood is
level with the base of the overhead cupboards.
Centre the mounting bracket on the rear panel of the overhead cupboard. Ensure the
mounting bracket is level and mark the 3 screw holes positions. Drill pilot holes into the rear
panel at the positions you have marked. Relocate mounting bracket and fasten it with
appropriate screws to the rear cupboard panel. Before tightening completely check the
level is correct. (Fig. 3)
