GDW45S 45cm Freestanding Dishwasher User Manual
Page 16
Protect Against Freezing
1.
Cut off the electrical power to the dishwasher.
2.
Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.
Drain the water from the inlet pipe and water valve. (Use a pan
to gather the water)
4.
Reconnect the water inlet pipe to the water valve.
5.
Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
P
lease take frost
protection measures on the dishwasher in winter. Every time after washing cycles,
please operate
as follows
Caring for the Dishwasher
Cleaning the Filter
The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any
part of the dishwasher.
Cleaning the Door
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in the figures
on the last
page and reinsert the entire assembly in the dishwasher, positioning it in its seat and pressing
downwards.
When cleaning the filters, don't knock on them. Otherwise, the filters could be
contorted and the performance of the dishwasher could be decreased.
WARNING!
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind.
WARNING!
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components.
Abrasive agents or some paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
NOTE:
If your dishwasher cannot work because of the ice,
please contact professional service persons.
- Inspect the filters for block
ages
after every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
Remarks:
The entire filter assembly should be cleaned once a week.
NOTE:
Cleaning the Spray Arms
I
t is necessary to clean the spray arms regularly for hard
water chemicals will clog the spray arm jets and bearings.
To remove the upper
spray arm, hold the nut, rotate the arm
clockwise to remove it.
To remove the lower spray arm, pull out the spray arm upward
Wash the arms in soapy and warm water and use a soft brush
to clean the jets. Replace them after rinsing them thoroughly.
Open
