-4-
Assembly Instructions
COMPONENTS
• Remove all components from package.
ADDITIONAL REQUIREMENTS
The following items are not included, but are
necessary for the proper assembly of your heater,
DO NOT attempt to assemble without proper tools.
• Philips screwdriver w/medium blade.
• Adjustable opening wrench.
• Leak Detection Solution (Instructions on how to
make solution are included in step)
Note: You must follow a II steps to properly
assemble heater.
WARNING: California Proposition 65 Combustion
by products produced when using this product
contain chemicals known to the state of
California to cause cancer, birth defects, and
other reproductive harm.
HARDWARE
Description
Picture
Qty.
Large Bolt
2
Small Nuts
4
Small Bolt
8
Large Flat Washer
6
Cap Nut
9
Large Nuts
2
Small Screw
9
Wing Nut
3
Reflector Stud
3
Wrench
1
If The Problem Is
And This Condition Exists
Then Do This
Pilot Won’t Light
Note: Heater operates at reduced
efficiency below 40°F (6°C)
Cylinder valve is closed
Open valve
Blockage in orifice or pilot tube
Clean or replace orifice or pilot tube
Air in gas line
Open gas line and bleed it (pressing
control knob in) for not more than 1 - 2
minutes or until you smell gas
Low gas pressure with cylinder valve fully
open
Use match to light pilot; obtain new igniter
and replace
Igniter fails
Pilot Won’t Stay Lit
Dirt built up around pilot
Clean dirt from around pilot
Connection between gas valve and pilot
assembly is loose
Tighten connection and perform leak
check
Thermocouple is not operating correctly
Replace the thermocouple
Burner Won’t Light
Gas pressure is low
Turn cylinder valve OFF and replace
cylinder
Blockage in orifice
Clear blockage
Control knob is not in “ON” position
Turn control knob to on
Burner Flame Is Low
Gas pressure is low
Turn cylinder valve off and replace
cylinder
Outdoor temperature is less than 40°F and
tank is less than 1/4 full
Use a full cylinder
Supply hose is bent or kinked
Straighten hose
Control knob fully on
Check burner and orifices for blockage
Carbon Build-Up
Dirt or film on reflector and burner screen
Clean reflector and burner screen
Thick Black Smoke
Blockage in burner
Remove blockage and clean burner
inside and outside
Troubleshooting
