HOMCOM 800-078, Assembly Instruction Manual, Page: 4 / 22

Coffee Maker
Page 3 of 21

Before removing any of the parts and accessories, make sure the three lights are on, press
the power button
to the off position “O” and unplug the appliance.

If coffee does not drip, the filter is blocked. Turn off the appliance and allow it to cool down.
The blockage may be caused by the coffee being too finely ground. See the
“PROBLEMS
AND CAUSES” section.

WHEN CLEANING THE FROTHED MILK DISPENSING TUBE: Place a large cup under the
tube. Fill the milk reservoir with water and place it back on the unit. Turn the Froth Control
Knob clockwise to the clean position “ ” then press and hold the latte/clean button for 3
seconds and release to activate the clean function. Let the unit dispense the water through
the tube for approximately 30 seconds and then press the Latte/Clean Button once to stop
the process.

Do not place on or near a hot gas or electric burner, or in a heated oven.

Do not use appliance for anything other than its intended use.

Do not leave the appliance unattended when in use.

This appliance is intended to be used in household and similar applications such as:
– Staff kitchen areas in shops, offices, and other working environments.
– Farm houses.

Never submerge the appliance in water or other liquids!
Danger of electric shock!
CAUTION: PRESSURE
To avoid possible burns to body parts and/or other injury from hot steam and water or damage to the
unit, never remove the water reservoir or the porta-filter while your espresso/cappuccino maker is
brewing coffee or frothing. Make sure the three lights are on before you can remove the porta-filter
to make additional cups of coffee. If you need to add more water or milk to the reservoirs, please
make sure the three lights are on and ensure to switch off the unit by pressing the red button on the
side of the unit to the off position “O”.