HOMCOM 800-078, Assembly Instruction Manual, Page: 15 / 22

Coffee Maker
Page 14 of 21
4. Empty the water tank and refill it with 600ml clean water, and press Espresso and Latte
buttons simultaneously again and the appliance continues to perform descaling, at that time,
the six indicators slowly flash alternately, after working for about half an hour, the appliance
stops working and goes back to the standby condition.
NOTE:
1) You can press any functional buttons to perform the corresponding function when the appliance
reminds you to perform descaling. The appliance will continue to remind you to perform this task
after you complete the corresponding function.
2) The descaling process can be stopped at any time by pressing any button, then the appliance will
continue to remind the user to perform descaling. The appliance will enter normal standby
mode only after the whole descaling process has been completed.
Cleaning the milk reservoir and frothing tube
Even though you can store the milk reservoir with left over milk in the refrigerator, it is important to
clean the reservoir and frothing tube regularly to avoid clogging and building residues. To clean the
milk reservoir, please follow the instructions listed below:
1. Remove the milk reservoir from the unit and remove the lid of the reservoir.
2. The steam tube connector can be detached by rotating, you can clean it in tap water. After
cleaning, please fix it into the milk reservoir lid by rotating.
3. When cleaning the milk reservoir, you can open the silicon sheet (do not pull it out) and wash
it by tap water and place in back in the machine.
4. Pour any leftover milk out, rinse and wash the milk reservoir and its lid thoroughly with warm
soapy water, and dry well. Do not use abrasive cleaners and scouring pads, as they will
scratch the finish. The milk reservoir is also dishwasher safe (top rack). Do not place the lid
of the milk reservoir on the dishwasher.
5. Place a large empty cup under the frothing tube.
6.
Turn the Froth Control Knob clockwise to the clean position “ ” then press and hold the
latte/clean button for 3 seconds and release to activate the clean function. The unit will start
releasing steam through the frothing tube, let it run for a few seconds until you do not see any
milk in cup. When done press the Latte/clean button once to stop the process.
7. Dispose any water left in the milk reservoir and place it back in the unit.
8. Note : For disassembling the milk reservoir, you should raise it up a little, then pull it out.