Operation
ADH-Series | Version 1.02
15
8.1 Dressing of workpieces
Up to 3 mm can be planed off in one planing pass. This
planing thickness may only be used with:
- sharp planing knives,
- soft woods,
- maximum workpiece width can be used.
If these characteristics are not observed, there is a risk
of overloading. Always machine a workpiece in several
operations until the desired material thickness is rea-
ched.
Dress workpieces with the machine as follows:
Step 1: Crank the thicknessing table to the lowest position
by turning the hand wheel (G, Fig.17).
Fig. 17: Handwheel thicknessing table
Step 2: Use a hose clamp to connect the suction hose to
the suction socket of the machine frame and
the suction socket of the planer table (Fig. 18).
Fig. 18: Connect suction hose
Step 3: Position the suction hood using the two brackets.
Fig. 19: Assembly of chip suction hood
Step 4: Adjust the planer shaft bridging protection with
the knurled screw (I, Fig.20).
Step 5: By loosening the locking knob (J, fig.20), the cut-
ter head's blade guard can be moved sideways
and the blade guard adjusted to the correct
width.
Step 6: After the adjustments have been made, retighten
the locking knob (J, Fig.20).
DANGER!
Check the electrical connection, cables and contacts
before commissioning.
Wear ear protection!
Wear protective goggles!
Wear safety shoes!
Wear protective work clothing!
Wear a dust mask!
NOTE!
The bracket (H, Fig. 19) on the chip extractor hood
activates a safety switch on the machine. If this
safety switch is not activated, the machine cannot be
started!
Summary of Contents for ADH 2540 230V
Page 26: ...www holzstar de ...
