¡ERROR! UTILICE LA PESTAÑA INICIO PARA APLICAR ÜBERSCHRIFT 1 AL TEXTO QUE DESEA QUE
APAREZCA AQUÍ.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Page 31
Ponceuse à rouleau/ mini wide belt sander ZS640P/ZS970P
13.7
Adjusting the sanding drum drive belt
The drum is driven by one belt and powered by the main motor. If the belt become too loose,
remove the right end guard, front guard, and then adjust the position of the motor (height) by
turning the M12 nuts on the height adjustment bolts (See figure). (for model
：
DS-
25
、
26
、
380
、
38A
、
13
、
13A)
If the motor becomes damaged and needs to be replaced, remove the bolts on the bottom of the
motor base plate, and remove the entire motor assembly.
13.8
Replacing the conveyor belt
If the conveyor belt becomes too worn, the workpiece will not be fed effectively. To replace the
conveyor belt, remove the guards at both ends of the sander, and remove the four fix screws at
the bottom of the feed table assembly. The feed table can then be removed so that the feed belt
can be replaced. (See figure)
Height Adjustment
Bolt
5/16” nut
Screws
Nuts
Summary of Contents for ZS640P
Page 61: ......
