CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
28
MSM100Neo
17
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
W A R N I N G
Danger due to electrical voltage! Handling the machine with the power supply up
may result in serious injury or death. For this reason, always disconnect the machine
from the power supply before cleaning, servicing or maintenance work and secure it
against accidental start-up!
17.1
Cleaning
N O T I C E
Wrong cleaning agents can attack the varnish of the machine. Do not use solvents,
nitro thinners, or other cleaning agents that could damage the machine's paint.
Observe the information and instructions of the cleaning agent manufacturer!
Regular cleaning is a prerequisite for the safe operation of the machine and its long service life.
Keep the surfaces and ventilation slots of the machine free of dust and dirt. For cleaning, use a
soft cloth and a mild soap solution and, if necessary, a damp-free jet of compressed air.
17.2
Maintenance
The machine is low-maintenance and only a few parts have to be serviced. Nevertheless,
malfunctions or defects which could impair the safety of the user must be rectified immediately!
Regularly check that the warning and safety labels on the machine are in perfect and
legible condition.
Only use perfect and suitable tools.
Only use original spare parts recommended by the manufacturer.
17.2.1
Maintenance and Servicing Plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when using the machine within the specified limits:
Interval
Component
What to do?
Before every start of work
sanding belt
check for damage
power cord
Each time after completion
of work
Machine
remove dust and dirt
Spark-trap
Emptying
weekly
Ventilation slots
Motor
remove dust and dirt
As required
sanding belt
replace
17.2.2
Replacing the sanding belt
W A R N I N G
Before opening the cover, make sure that the machine is disconnected from the
power supply and secured against accidental start-up. If you have just used the
machine, wait a few minutes before opening it until the grinding wheel and machine
have cooled down.
